SIGNMASTER CUT TUTORIAL HOW TO

Vinyl is on a roll - so the max height could be as long as the

Set the document width the vinyl width (22' or 13').

The document properties dialog box will open. Step 1: From the 'File' menu > select 'Document Properties' If the width is larger than the height, the machine may rotate your design by 90 degrees. Warning: the document height is must be larger than the document width.

Set Document Height to a minimum of 23'.

Machine rollers will take up 1' on either side of the vinyl.

All vectors must be contained within the bounds of the document canvas.Дocument Setup You will need to size your page in your drawing program appropriately for the width of vinyl that you are using.

The vinyl cutter drivers can only interpret cut lines.

The vectors must be lines only, with no fill.

Your vinyl cutter files must contain only vectors.

This tutorial uses inkscape to prepare the files for the vinyl cutter Roland Camm-1 CX-24 but most of the instructions will be similar if you have another machine.

The vinyl cutter is primarily used for cutting vinyl into signs or stickers, but can also be used to cut copper tape into circuit traces.

SIGNMASTER CUT TUTORIAL HOW TO

Vinyl Cutter How to use Vinyl Cutter and make the files with InkscapeДЄ vinyl cutter is a uses a computer-controlled blade to cut out shapes designed using vector graphics.

Week 16: Interface and application Programming.

Introduction to Molding and Casting- Video Why did we put a 20MHz crystal on the Hello FTDI?

Introduction to 3d scanning and printing- Video Use an Arduino UNO as an ISP to program your first FabISP Parametric Modeling of a Box Beam in Antimony

Week 1: Principles & Practices, Project Management.

Signmaster cut tutorial